position:HOME - NEWS - Enterprise Dynamic
Common faults and troubleshooting methods of intelligent parking system
Time: 2019-06-14 12:56:00


The application of intelligent parking system not only brings a lot of convenience to our life, but also ensures our safety. With the development of intelligent age, the market demand of intelligent parking system is increasing day by day, and its effect is obvious. However, due to technical problems, the intelligent parking lot sometimes appears some malfunction, so how to solve this problem?

The following sorting out the intelligent parking system common faults and troubleshooting methods, for your reference!


Common failures of intelligent parking system 1:

When the card is placed near the card reader, the buzzer will beep. The Chinese display screen will not respond, and the card number cannot be seen in the software monitoring interface (abnormal communication between the card reader and the computer).

Possible reasons:

(1) the connection between the controller and the computer is not correct;

(2) set up in the software serial port is not consistent with the actual use of serial port.


Common failures of intelligent parking system 2:

If you put the card near the card reader, you can hear the sound of "tick tick", but you can't open the gate. The Chinese screen shows "invalid card".

Possible reasons:

(1) the card is invalid (no issued or authorized card);

The connection between the gate and the card reader is incorrect or not connected.

(3) card reader has been in the computer control state (the control switch has been short), parking monitoring did not open.


Common failures of intelligent parking system3:

The car won't go through the brake.

Possible reasons:

(1) the buried coil is incorrect or the coil is damaged or broken;

(2) insufficient power of vehicle detector (Max250mA) or improper adjustment of induction sensitivity (too high or too low);

(3) the "COM" end of the ground sensor and the "GND" common end of the gate controller are disconnected or in bad contact.


Common failures of intelligent parking system 4:

Click the "brake" button in the monitoring interface. The gate is not open, but the manual button can be used to open the gate.

Possible reasons:

(1) there is no short connection in the "control switch" in the card reader (it is disconnected when leaving the factory, and it is in the offline working state, and it must be short connection in the online state when controlling with the computer network);

(2) the computer and card reader can not communicate normally, the controller can not receive the switch command. (check whether the computer serial connection is normal and whether the parameters are set correctly)


Common faults of intelligent parking system 5:

With image contrast function, but can not see the image when entering the parking monitoring interface.

Possible reasons:

Video card installation is not correct (such as driver installation is not correct);

(2) the camera is not powered up or the camera and video card connection is not correct;

(3) parking software parameter Settings are not correct (such as the entrance first choose not camera).


Common failures of intelligent parking system 6:

The Chinese display does not display.

Possible reasons:

Poor power contact of Chinese display screen; Display screen power supply is bad;


Common failures of intelligent parking system 7:

The automatic card ejector cannot release the card (after detecting the vehicle and pressing the "card access" button, the card ejector does not respond or the card ejector ACTS but cannot release the card).

Possible reasons:

(1) if the card machine does not respond after pressing the "card" button, it may be that the card machine has not been put into the card or the card machine has not added power (power plug off);

(2) if the "take the card" button is pressed, the card machine has action but can not out of the card, may be out of the slot gap is too small, the card is stuck and can not spit out;


Common failures of intelligent parking system 8:

Click "school time" in the entrance and exit monitoring interface of the parking lot, "school time successfully" will appear first, and then "communication error/failure" will be prompted (all hardware devices are in good condition after inspection).

Possible reasons:

(1) the line encountered strong interference (such as the communication line and ac power line in common);

(2) network expander damage, input/output signal distortion;

(3) in software Settings, communication delay setting is too low (generally the minimum is 200ms), too low will cause communication failure;


Common failures of intelligent parking system 9:

The card number transmitted to the computer is sometimes correct (the switch can be opened), and sometimes it cannot be opened.

Possible reasons:

(1) the line encountered strong interference (such as the communication line and ac power line in common);

(2) the line is too long, beyond the effective communication distance (200M), the signal seriously decline gradually;

(3) card reader control motherboard ground (signal) and ac source (power source) short circuit, resulting in communication interference.

With the development of intelligent age, the market demand of intelligent parking system is increasing day by day, and its effect is obvious. However, due to technical problems, the intelligent parking lot sometimes appears some malfunction, so how to solve this problem?

The following sorting out the intelligent parking system common faults and troubleshooting methods, for your reference!


 

SSCL Intelligent Technology Co., Ltd.

Hot line: +86 18902560399

Alibaba site: https://fssscl.en.alibaba.com/






Contact Us

You can send us an email and we'll get back to you, asap.